Pneumatic Piston Seal

KASTAŞ NO	D (H11)	d (h10)	B	d1 (±0,2)	b	s	h
K55-016	16	4,5	4,4	6,9	3,4	2	2,3
K55-020	20	6	5,5	9,4	4,4	2,5	2,8
K55-025	25	7	6,4	10,8	5,4	3	3,5
K55-032	32	8	7,5	12,5	6	3	3,5
K55-040	40	8	8,5	17	7	4	4,5
K55-050	50	10	10	26	8	4	4,5
K55-063	63	12	10	26	8	4	4,5
K55-080	80	16	11,4	30	9	5	5,5
K55-100	100	20	12,9	35	10,9	6	6,5

K55 is a single acting complete piston seal which consists of an aluminum plate vulcanized with elastomeric nitrile rubber using special production methods.

PRODUCT ADVANTAGES
• Ready to fit complete piston
• Reliable pressure application at the end of stroke by the venting passages.
• Low friction and smooth running due to sealing lip geometry
• Easily fastened to the piston rod without using additional sealing elements
• Economical sealing solution

APPLICATION
Standard pneumatic cylinders and after market.

MATERIAL		CODE
NBR	70 SHORE A	NB^₇₀₀₁
ALUMINUM		AL^₉₉₀₁

OPERATING CONDITIONS
MEDIA	Prepared , dried and de-oiled compressed air
TEMPERATURE	-30°C +105 °C
PRESSURE	≤12 Bar
SPEED	≤1.0 m/sn

Note: The above data are maximum values and cannot be used at the same time.

SURFACE ROUGHNESS	Rmax
Sliding Surface Ød	≤4 μm
INSTALLATION K55 is pushed onto the piston rod on the clamping flange towards the rod and fixed by fastening. The nut has to be secured. The sliding surface and the cylinder bore should be oiled with oil that must not go into the reaction with the sealing element during the installation process. NOTES For special applications that require high temperatures , K55 can be produced in FKM material.