Pneumatic Piston Seal

K58 - Pneumatic Piston Seal

General Features
Technicial Specifications

KASTAŞ NO	D (H11)	d (f8)	d1 (-0/+0,2)	d2(-0/+0,2)	B	B1	B2
K 58-032 PU	32,00	8,05	17,00	20,70	14,50	10,65	5,20
K 58-040 PU	40,00	8,05	21,40	26,50	15,20	11,70	5,80
K 58-050 PU	50,00	10,05	27,30	33,10	16,00	12,15	5,10
K 58-060 PU	60	10,05	25	31,8	19,20	15,85	5
K 58-063 PU	63,00	10,05	28,00	33,80	19,20	15,85	5,00
K 58-080 PU	80,00	12,05	29,00	34,40	22,00	17,50	8,50
K 58-100 PU	100,00	17,05	39,60	46,80	25,50	20,00	8,85

K58 is five piece double acting sealing set consists of aluminumbody , two elastomeric sealing elements , one guide ring , onemagnet and an O-ring for the inner sealing.

PRODUCT ADVANTAGES
• Ready to fit complete piston
• Low friction and smooth running due to sealing lip geometry
• Easily fastened to the piston rod without using additionalsealing elements
• Static seal on the inside diameter
• Easy installation
• Long service life

APPLICATION
All pneumatic cylinders in need of stroke control.

MATERIAL		CODE
PU	92 SHORE A	PU^₉₂₀₁
POM		PM_⁹⁹⁰¹
ALUMINUM		AL_⁹⁹⁰¹
MAGNET		MK_⁹⁹⁰¹
NBR	70 SHORE A	NB_⁷⁰⁰¹

OPERATING CONDITIONS
MEDIA	Prepared , dried and de-oiled compressed air
TEMPERATURE	-30°C +80 °C
PRESSURE	≤16 Bar
SPEED	≤1.0 m/sn

Note: The above data are maximum values and cannot be usedat the same time.

SURFACE ROUGHNESS	Rmax
Sliding Surface	≤4 μm
INSTALLATION K58 is pushed onto the piston rod on the clamping flange towards the rod and fixed by fastening. The nut has to be secured. The sliding surface and the cylinder bore should be oiled with oil that must not go into the reaction with the sealing element during the installation process. NOTES For special applications that require high temperatures , K58 can be produced in FKM material.